Permanent Magnet Motor Gear Motor Micro Motor AC Motor 66r / Min(15 RPM)

MotorsAC 220V, rated speed 1 rpm, rated 28kg.cmAC 220V, rated speed 2.5 rpm, rated 23kg.cmAC 220V, rated speed 5 rpm, rated 15kg.cmAC 220V, rated speed 10 rpm, rated 8kg.cmAC 220V, rated speed 15 rpm, rated 5kg.cmAC 220V, rated speed 30 rpm, rated 2.8kg.cmAC 220V, rated speed 66 rpm, rated 1.5kg.cmAC 220V, rated speed 90 rpm, rated 1.1kg.cmWeight: 0.23kgDimensions:70KTYZ, 60KTYZ, 50KTYZ may be reversing, direction can be changed by changing the wiring.TYC49 work for non-directional, directional uncertainty does not work direction, the power of breaking could change the direction of rotation of the motor, another encounter strong resistance when the motor will automatically reverse to avoid burning motor overload, the motor reduction gear for POM engineering plastics, demanding careful shot! ! !Another series motors which power and output speed as follows:Motor Caution:1. Before using make sure the motor voltage is correct, even if the DC motor to confirm the adequacy of the supply current.2. Use not overload, overload reasons mainly of two parts, and axial force, the load of the motor can not exceed the rated discontinuity axial and radial shaft may exceed the allowable stress axis, plus after the load should not exceed the rated current of the motor measured current, general motors must be accompanied by burning fuse to avoid overloading the motor.3. Do not store or operate in or humid environments, but also do not place in corrosive gas, the effect will reduce motor4. The motor shaft assembly transmission parts such as gears, pulleys when, in press-fitting Do not knock the exception.5. Power on the positive and negative terminals of the motor when you want to solder, soldering iron temperature of 340 ± 40 , heating time within 3 seconds, not the plastic deformation, at work, so that the solder flows into the motor point or broken wire ends, it will motor function decline.6. When the installation of the motor, note the screw is too long, too long to prevent the screw press touch electrical parts inside.7. concept: for example, drive pulley, 10KG.CM , belt pulley radius 1CM there 10KG tension pulley radius 5CM if only 2KG belt tension.8. Common units: 1N.M = 10KG.CM == 0.1KG.M, 1HP = 750W, 1W = 1V.A

• Motors